Configuring In-band Management
73
Figure 45
Add Virtual Circuit Menu
3
Build a PVC on the far-end PathBuilder S330/S310, using the MCPU as side A of
the circuit. Set the following parameters on the Add Virtual Circuit screen:
n
Shaper Number
—Choose the number corresponding to the desired shaper
value. You assign the shaper number from the MCPU Shapers screen. See
“Configuring MCPU Shapers” in Chapter 4, for details.
n
IP Address
—You must use a different subnet than the one you used for the
near-end PathBuilder S330/S310.
n
Subnet Mask
—Specify any acceptable address (for example, 255.255.255.0)
n
VPI/VCI
—You must use the same values as you did for the near-end
PathBuilder S330/S310.
4
On the Manage IP Network Configuration menu, select
[3] Default Gateway
Configuration
and set the following:
a
Set the default gateway on the far-end PathBuilder S330/S310 to the PVC IP
address you set for the near-end PathBuilder S330/S310 in step 1.
b
Set the default gateway on the management station to the local host IP
address of the near-end PathBuilder S330/S310.
For details about setting the default gateway, see “Configuring the Default
Gateway” earlier in this chapter.
5
Apply your IP configuration changes.
a
From the main menu, select
[1] System Administration
.
b
From the System Administration menu, select
[3] Manage IP Network
Configuration
.
c
From the Manage IP Network Configuration menu, select
[1] Local Host IP
Configuration
.
d
From the Local Host IP Configuration menu, select
[2] Apply IP Configuration
Changes
.