| Cassettes and Side Channels
2
• Align the tops of each installation cassette to the top of the
window opening and attach using the screws provided,
drilling through the predrilled holes.
• Adjust the cassette placement to accommodate
obstructions to the bottom rail, such as a window crank or
handle.
• Use a carpenter’s level to check that the cassette is level and
aligned. Attach using the screws provided and drill through
the predrilled holes.
INSIDE MOUNT
SHADE INSTALLATION
INTO CASSETTE
OUTSIDE MOUNT
• Attach the back of each installation cassette using one
screw per predrilled hole.
• Use a carpenter’s level to check that the cassette is level
and aligned.
Once you have installed the Cassette now it is time to
reassemble the shade back into the Cassette. Insert the
control side fi rst making sure the mechanism is turned just
like it was when removed, chain guard turned up towards
Cassette so chain is visable(picture below). Next push the idle
pin in and slowly insert the shade into the groove provided
by the internal bracket until the pin snaps into place. Then
reattach the CCL guide to the end plate making sure the
complete piece snaps into place in the correct groves.
• Align the square or round end caps and slide them
onto the end plates of the cassette. You will hear a
click when they are in place.
• Test the shade to ensure
it is operating correctly.
Once you have the shade back into the Cassette now it is
time to reattach the Fascia. The Fascia sits in a grove on
top of the Cassette and snaps into the end plates on the
right and left side. Insert the Round or Square fascia onto
the Cassette back grove & rotate down to clip into position
on the right and left side, you will hear it snap into place.
The fi nal step is to attach the end caps on the right and left
side of the Cassette.
