6. INSTALLATION
6.3 ELECTRO-ACCESSORIES INSTALLATION
•
Before electrical manipulation with the mixing chamber the main power supply
must be turned off!
•
Electrical installation must be performed pursuant to qualified electrical engi-
neer’s design.
•
Only a qualified electrical engineer may perform the installation.
•
All valid country-specific regulations and directives must be observed during
installation.
•
Wiring diagrams on the product are superior to those listed in this manual!
•
Before installation make sure that terminal markings match the markings on the
electrical circuitry scheme. In case of doubt contact your contractor and do not
connect the heating unit under any circumstances.
L
L
N
N
1~230V
PE
PE
•
The electrical parameters are printed on the servo drive’s identification plate.
•
Follow the setup instructions of the relevant servo drives.
6.3.1 Adjusting the servo drive’s position
The position of the servo drive must be adjusted using the controller.
Summary of Contents for SAV-MIX-2
