2N TELEKOMUNIKACE a.s., www.2n.cz
38/92
Programming Procedure
Having entered the programming mode, you can change any programmable value(s)
in any order. Proceed as follows: enter the parameter (service) number and value. Use
an asterisk as a separator or Enter. In general, the function has the following format:
parameter number
value
The parameter number has three digits (see the table). After you enter the number
a n d
a n
a s t e r i s k ,
reports the number, current value and potential range of the parameter to
2N LiftIP
®
be programmed. After you enter the value and another asterisk,
announces:
2N LiftIP
®
“New value stored”, or “Invalid value, new value not stored” if the value is beyond the
allowed range.
2N
LiftIP
®
reads the parameter number and new value for checking purposes.
Caution
A drawback of some phones is that they go “deaf” for a fraction of a
second whenever you press a button (send DTMF). In that case, you
cannot hear the whole text and are recommended to use another phone.
Programming Error
If you mistype a digit while entering a function/value and find it before clicking
the asterisk, press
to cancel the whole number and enter a new one.
If
rejects a parameter number or value, you can go on programming –
2N LiftIP
®
re-enter the whole function number although you only typed a wrong value.
If you have programmed and saved a wrong value, re-enter a correct value.
Programming End
If you are calling
via a phone number, hang up to quit programming.
2N
®
LiftIP
Press
to return to the preceding menu.
