2N ISDN BRI GSM, User Manual

Page: 91 / 109

2N - ISDN BRI GSM Enterprise Gateway
9.5. List of Terminal AT Commands
All commands start with AT by default. (Note: Some of the below
mentioned AT commands may not be available in the current
firmware versions.)
Basic AT Commands
A/
...repeat last command (without AT)
I3
...copyright & firmware
I4
...serial number
&FRES
...factory defaults & reset
&V
...view active parameters (system)
&VI
...view active parameters (isdn)
&V0
...view active parameters (common)
&V#
...view active parameters (modules 1..2)
&V9
...view active parameters (inc. groups)
&VALL
...view all group parameters
&P
...view pseudo params
&N#
...view network params (net 1..8)
&NALL
...view all network params
&A
...view autorouting table <SPACE...continue>
&R
...view lcr-routing table <SPACE...continue>
&T
...view bris + modules totals
&TMOD
...view all modules totals
&G##=atcommand
...send at command to module 0..1 (ended by OK from gsm)
&G##=xtcommand
...send at command to module 0..1 (ended by <CR> from user)
&G##=cmd
...cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON), (ATBAUD)
&GALL=cmd
...cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON)
&S
...view aux, bris, modules status
&S##
...view aux, bris, one module status (ax,px,ex,0..1)
&S=info
...view all modules selected info (by at&S##)
&Q##
...view signal quality on module 0..1
&QALL
...view signal quality on all modules
&L
...view logfile from recent <SPACE...continue>
&C
...view buffer (calls) from recent <SPACE...continue>
&CR
...read buffer from the oldest <#...erase & continue>
&BSYS=cmd
...cmd for system (RESET)
&XG
...view conn table/gsm (call states)
(&XG##
...view call details for gsm channel)
&M0
...disable ansi colors
81