75
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Caution
The count of user accounts is file-licensed. Refer to
for the current GSM gateway licence
Management–>Licence key
details.
Users
This section helps you manage the SMS users. Select a communication protocol for
user adding (SMTP/POP3 or SMPP).
Add user
–
User group
assign the user to a User group.
–
User full name
define the system user name.
–
Replace dial for outgoing SMS
define the number
(CPN) to which the
user's outgoing SMS messages shall be sent.
–
Access type
select the communication protocol for SMS processing:
Email (SMTP/POP3)
– use SMTP for SMS sending and POP3 for
SMS receiving.
SMPP (SMSC)
– set the GSM gateway into the 'SMS centre' mode.
SMPP (ESME)
– set the GSM gateway into the 'ESME - External
Short Messaging Entity' mode.
Login name (without domain) –
define the login name for the client
Email.
System ID –
SMSC user
.
ID
Password –
SMSC/SMTP user password.
–
System ID (for authentication on remote side)
ESME user ID.
–
Password (for authentication on remote side)
ESME user ID.
set the TCP parameter into the client/server mode.
TCP type –
Server address –
set the server IP address and TCP server transport
port.
Message direction of Esme –
set the ESME user details:
Transceiver –
ESME works as a transmistter/receiver.
Transmitter –
ESME works as a transmitter.
Receiver –
ESME works as a receiver.
Address range –
set this parameter if required so by SMSC for SMS
receiving.
Delivery status required
– set the SMS sending request for outgoing
SMS delivery confirmation
.
Send message as Flash SMS
–
activate the Flash SMS function for
outgoing SMS messages.
Note
You can set the
parameter only if the
Delivery status required
SMTP/POP3 protocol is used.
With SMPP, the delivery information is active automatically in case the
service is required by the SMPP counterparty or via an incoming SMS
message from the GSM/UMTS network.
