44
2N TELEKOMUNIKACE a.s., www.2n.cz
®
4.5 Basic Configuration – Step by Step
This subsection helps you put your BRI gateway in operation for the first time. Refer to
the paragraphs of
for more detailed settings.
S. 3
Install the GSM gateway as instructed in
. Remove the SIM cards or
Subs. 2.2
insert the PIN–disabled SIM cards before the first launch.
Connect the GSM gateway to the Ethernet to be able to get connected to the
address mentioned in
, page from the web interface. If the default IP
Subs. 4.1
address of your gateway is not suitable for your Ethernet installation, change the
IP address setting as follows:
Disconnect the configuration terminal from the Ethernet.
Disconnect the GSM gateway from the Ethernet.
Get an Ethernet switch or an Ethernet crossed cable.
With the crossed cable, interconnect the configuration terminal directly with
the GSM gateway.
With the Ethernet switch, connect the configuration terminal and GSM
gateway to the switch. We do not recommend you to connect any other
device.
Change the IPv4 setting in your configuration terminal Ethernet settings to,
e.g.: IP=192.168.1.200, Net mask: 255.255.255.0
Open your web browser and enter the IP address of your GSM gateway.
Complete the factory login data.
Change the required settings in the Gateway configuration – Ethernet
section and save the changes into the GSM gateway.
configuration
Connect the GSM gateway to a standard Ethernet.
Rechange the IP settings of the configuration terminal and reconnect the
terminal to a standard Ethernet.
Enter the new IP address of your GSM gateway to get connected to the web
interface.
Set the current time and date for the GSM gateway in the Gateway control –
menu.
Date/Time
Check the
for 'unlocked' in the
Licence status
Gateway control –
menu. If the status is not unlocked, your GSM gateway is not
Firmware/Licence
equipped with the proper licence (refer to
). Contact your dealer for the
Subs 4.2
licence key.
Set the correct PIN code value in the Gateway configuration – System
menu to meet the PIN code of the SIM cards used.
parameters
Set new login data in the
menu.
Gateway configuration – Login configuration
Switch off the GSM gateway and insert the SIM cards. Connect the antenna to
the GSM gateway and switch the gateway on.
The GSM gateway factory configuration allows you to make outgoing calls without
any additional programming. All you have to do is set the correct values for the
BRI ISDN and VoIP interfaces.
Should you have problems with the gateway functions, follows the instructions below
please:
Read the User Manual carefully and check all the parameters.
Find answers to your questions at
(Frequently Asked Questions).
http://faq.2n.cz
Contact your servicing centre.
