Quick Step-by-Step Manual
3.2
67
Yes
in the following dialogue and wait for configuration download from
the gateway.
7.
Move to the
Gateway configuration>System parameters
section.
8.
To use remote control over TPC/IP, change the
IP address
,
Subnet
mask
and
IP router
parameters.
9.
In case you are using SIM cards with an active PIN, use the same PIN
for ALL of the SIM cards used. Fill in the same PIN code into the
PIN
parameter too.
10.
Change the
Configure gateway as
parameter to
ISDN-DSS1
. Click on
the
Save to gateway
button located below the configuration
parameters to save all the configuration parameters from the current
window into the gateway.
11.
Move to the
VoIP parameters
section. Here you set the proper
configuration for the VoIP SIP line. Fill in the IP address to be assigned
to the VoIP board into the
VoIP card / MGCP gateway
parameter. To
do so correctly, read Subsections 2.1 – VoIP Board and 2.4 – VoIP
Connection carefully. Having finished setting click on the
Save to
gateway
button. Note: All the VoIP card settings will be activated after
the gateway restart!
12.
Connect the Ethernet line to the Ethernet switch located on the VoIP
card. Then interconnect the basic and enhanced CPUs with the VoIP
card Ethernet switch (for description of the CPU board see Subs. 2.1 –
Basic CPU, Enhanced CPU).
13.
In the
GSM group assignment
section assign all the wireless modules
to the incoming and outgoing group 1 and then save the settings to the
gateway using the
Save to gateway
button.
14.
In the
GSM outgoing groups – GSM group 1
section set the following
parameters:
a.
SIM card switching mode = SIM 1;
b.
CLIR = default;
and save the settings into the gateway.
15.
In the
LCR table
add a new line with the following parameters:
NetworkID=Group 1, Groups=GSM group 1, PRI 2. Save the new table
to the gateway using the
Save to gateway
button.
Now the gateway is prepared for accepting all calls from the VoIP-SIP interface and
route them to the GSM / UMTS network. When all the wireless modules are busy, the
gateway will reject the call. All calls from the GSM / UMTS network will also be
rejected.
Should you have a problem with the correct function, please read this manual carefully
and check all parameters. For additional questions refer to the 2N
®
FAQ at
http://faq.2n.cz
. For a successful installation of the whole system we recommend you
to have a training certificate from 2N.
Quick Step-by-Step Manual for 2N
®
SIM Star
The configuration of the whole gateway is similar to that of a normal stand-alone
gateway but you have to make two extra steps:
Summary of Contents for BlueStar
