45
This chart is necessary for a correct LCR function, i.e. routing calls to GSM networks.
In individual lines there is all information about the GSM network of individual providers.
-
Name is the text name of the provider and is used for easy orientation in the chart.
-
Provider’s code is essential for the LCR function. The code of the provider must be
filled in here in exactly the same way as it is transmitted by the GSM network (e.g.
Paegas 23001). You can find it in the menu “Gateway control > Diagnostics”. (A SIM card
of the provider must be inserted in the gateway.) If the provider’s code is quoted in the
GSM destination chart, in the diagnostics menu you will find the provider’s text name for
better orientation.
-
SMS centre number - must be filled in here in its complete form. This number is
essential for future SMS transmission from the ISDN GSM gateway.
-
Prefix - Enter the prefix only if you do not use the function of outgoing call routing
into GSM “According to position”. all calls containing prefixes included this list are routed
through this provider (if the provider is logged to a GSM channel). The prefix is followed
by the number of signs (e.g. Paegas = “6”) that make the number complete. This
guarantees that any dialling into the GSM network starts after the last digit, not after the
timeout mentioned in 6.5.4.1 page 40 in “Dialling parameters”. Prefixes must be entered
in a defined format, 603;606;777..., e.g. if the national destination prefix is filled in (see
6.5.4.3 page 44). If not, prefixes should have the 0603;0606;0777,... format. Be sure to
complete the “Installation site” chart carefully to avoid dysfunction (see 6.5.4.5 page 45).
-
According to position –
From the firmware version 9.00 up, the ISDN GSM
gateway provides two ways of outgoing call routing into GSM – according to GSM
provider (network number) and now according to SIM card position in the gateway. This
parameter is useful where you have SIM cards from one and the same provider in your
ISDN GSM gateway but want to set the outgoing call routing to GSM for each GSM
module separately. Enter the prefixes as in the “National destination” chart. In case you
use this mode, you can select destinations GSM1 (for position 1) and GSM2 (for position
2) in the “Tariff rates>Priorities” section
.
ATTENTION! It's necessary, for the correct function, to fill in the number of the network, the title
and the SMS center of the used operator in the GSM destination chart (it must be from those
operator, whose SIM cards are used in the ISDN GSM Gateways) and these destinations must
be filled in correctly to the chart in "tariff-priorities" section
6.5.4.5
Installation site
For a correct LCR function it is necessary to specify where the gateway is located.
National destination – select the place where the gateway works from the National
destination chart.
International destination - select the place where the gateway works from the
International destination chart.
6.5.4.6
Trunk number
In case you have enbled DISA to GSM function and the gateway is connected to ISDN-
bus with more TE terminals. It is necessary to add MSN number of the GSM gateway for
Fig.41:
Installation site
Summary of Contents for ATEUS
Page 1: ...ATEUS GSM ISDN GATEWAY Lite User s Manual Version 1 5 ...
Page 2: ......
