ZyXEL Communications WX3310-B0, Руководство пользователя

Страница: 15 / 118

Chapter 1 Introduction
WX3310-B0 User’s Guide
15
• Repeater mode (modem/router to the WX3310): Press the WX3310 WPS button once to copy the WiFi
settings from your modem/router to the WX3310. Press the WPS button on your modem/router within
two minutes. Wait for the WPS LED to turn steady green, which indicates that the WPS process is
finished. If it turns red, the WPS process has failed.
• Repeater mode (the WX3310 to the wireless client): Press the WX3310 WPS button twice within 7
seconds to copy the WiFi settings from the WX3310 to a wireless client, such as your smartphone or
laptop. The WPS LED should start blinking. Press the WPS button on the client within two minutes. Wait
for the WPS LED to turn steady green, which indicates that the WPS process has finished. If it turns red,
the WPS process has failed.
Note: You must activate WPS in the WX3310 and in another wireless device within two minutes
of each other.
Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using
the first 5GHz or 2.4GHz SSID on the WX3310 (in AP or repeater mode).
For more information on using WPS , see Section on page 43 .
1.7 The RESET Button
If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the
RESET button at the back of the WX3310 to reload the factory-default configuration file. This
means that you will lose all configurations that you had previously saved, the password will be reset to
the default key on the device label. The WX3310 will be reset to obtain an IP address from a DHCP
server.
1.7.1 Using the RESET Button
1
Make sure the power LED is on (not blinking).
2
Press the RESET button for one to five seconds to reboot the WX3310.
3
Press the RESET button for longer than five seconds to set the WX3310 back to its factory-default
configurations.