ZyXEL Communications WAH7601, Руководство пользователя

Страница: 74 / 111

Chapter 11 WiFi
WAH7601 User’s Guide
75
You can use the MAC address filter to tell the WAH7601 which devices are allowed or not allowed to use
the wireless network. If a device is allowed to use the wireless network, it still has to have the correct
information (SSID, channel, and security). If a device is not allowed to use the wireless network, it does
not matter if it has the correct information.
This type of security does not protect the information that is sent in the wireless network. Furthermore,
there are ways for unauthorized wireless devices to get the MAC address of an authorized device. Then,
they can use that MAC address to use the wireless network.
11.5.2 Signal Problems
Because wireless networks are radio networks, their signals are subject to limitations of distance,
interference and absorption.
Problems with distance occur when the two radios are too far apart. Problems with interference occur
when other radio waves interrupt the data signal. Interference may come from other radio
transmissions, such as military or air traffic control communications, or from machines that are
coincidental emitters such as electric motors or microwaves. Problems with absorption occur when
physical objects (such as thick walls) are between the two radios, muffling the signal.
11.5.3 WiFi Protected Setup (WPS)
Your WAH7601 supports WiFi Protected Setup (WPS), which is an easy way to set up a secure wireless
network. WPS is an industry standard specification, defined by the WiFi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device to
authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set up
a secure network by themselves.
Push Button Configuration
WPS Push Button Configuration (PBC) is initiated by pressing a button on each WPS-enabled device, and
allowing them to connect automatically. You do not need to enter any information.
Not every WPS-enabled device has a physical WPS button. Some may have a WPS PBC button in their
configuration utilities instead of or in addition to the physical button.
Take the following steps to set up WPS using the button.
1
Ensure that the two devices you want to set up are within wireless range of one another.
2
Look for a WPS button on each device. If the device does not have one, log into its configuration utility
and locate the button (see the device’s User’s Guide for how to do this - for the WAH7601, see
Section
11.5 on page 73 ).