Chapter 5 Powerline Network Setup Tutorial
PLA Series User’s Guide
48
6
in this section to set the same, new
Network Name
for all remote adapters you
want to add to your new network.
7
Check you have added the adapters correctly by changing the network name for the local adapter.
All adapters with the new
Network Name
now appear in the list of adapters on your network.
These adapters are now part of your new network.
Figure 33
Adapters on a New Powerline Network
• If you want to access any of your new powerline networks using the
ZyXEL PLA Series
Configuration
utility, change the
Network Name
on your local adapter to the network name
for the network you want to access. The adapters on that network will then display in the adapter
table, allowing you to select and configure each one.
5.7 Troubleshooting
The HomePlug (
) LED (light) should light up on your adapter when it successfully connects to
other adapters on your network. If it does not, try the following measures.
• Make sure the adapter is plugged in to a power socket and the power socket is turned on.
• Check you have entered the correct network name for your network.
• Check your powerline adapter is connected to the same electrical circuit as other powerline
adapters on your network.
Содержание PLA series
