ZyXEL Communications MS-7206, Руководство пользователя

Страница: 52 / 94

Chapter 7 Installing Cards
MS-7206 Hardware Installation Guide
52
7.1.2 Add a Management Card (System Is On)
Install the card in the MS-7206 chassis (refer to Section 7.3 on page 54 for details).
If there is another management card in the system, the new management card automatically
becomes the standby management card. If the firmware version of the new management card
is different than the firmware version of the existing management card, the new management
card does not function in the system.
7.1.3 Remove a Management Card
Refer to Section 7.4 on page 55 for how to physically remove the card from the MS-7206
chassis. If you remove the active management card, the standby management card takes over.
7.2 Interface Modules
This section describes the steps required to add and remove interface modules. If you want to
hot-swap interface modules, follow the steps below to remove the existing interface module
and add the new interface module.
You can install interface modules in slot 3, slot 4, slot 5, or slot 6.
7.2.1 Add an Interface Module (System Is Off)
1 Install the card in the MS-7206 chassis (refer to Section 7.3 on page 54 for details).
2
Turn on the system.
The system automatically detects what type of interface module is installed. You do not have
to configure the
Slot Setup screen.
7.2.2 Add an Interface Module (System Is On)
If the same type of interface module was previously installed in the slot, install the card in the
MS-7206 chassis (refer to
Section 7.3 on page 54 for details).
If a different type of interface module was previously installed in the slot or if no interface
module was previously installed in the slot, follow these steps.
1 Access the web configurator (see the User’s Guide for details).
2
Open the Slot Setup screen, and uninstall the existing type of interface module in the
slot (if necessary).