ZyXEL Communications GS1900 Series, Руководство пользователя

Страница: 145 / 263

Chapter 22 Configuration: Link Aggregation
GS1900 Series User’s Guide
145
Fig ure 144
Configuration > Link Aggregation > Global
The following table describes the labels in this screen.
22.2.2 The LAG Ma na g e m e nt Sc re e n
Use this screen to view LAG management settings. Click
C o nfig ura tio n
>
Link Ag g re g a tio n
>
LAG
Ma na g e m e nt
to open this screen.
Fig ure 145
Configuration > Link Aggregation > LAG Management
The following table describes the labels in this screen.
Table 91 Configuration > Link Aggregation > Global
LABEL DESC RIPTIO N
Global
LACP State Select
Ena b le
to activate the link aggregation control protocol.
LACP System
Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP “server”. The
LACP “server” controls the operation of LACP setup. Enter a number to set the priority of an
active port using Link Aggregation Control Protocol (LACP). The smaller the number, the higher
the priority level.
Load Balance
Algorithm Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the
IP/ MAC
Addre ss
distribution type. If the Switch is behind a router, the packet’s destination or source
MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP
address to make sure port trunking can work properly.
Select
MA C A d d re ss
to distribute traffic based on a combination of the packet’s source and
destination MAC addresses.
Select
IP/ MAC Addre ss
to distribute traffic based on a combination of the packet’s source and
destination IP addresses.
Apply Click
Apply
to save the changes.
Cancel Click
C a nc e l
to discard the changes.
Table 92 Configuration > Link Aggregation > LAG Management
LABEL DESC RIPTIO N
LAG Management
LAG Displays the link aggregation group (LAG), that is, one logical link containing multiple ports.
Name Displays the name of the link aggregation group.