FV563 Rev. - 12/2/14
Page 5
Spout Upgrade
To replace spout body, you must first turn water off, then remove spout with sensor cable.
16
4.3)
HW6 (Hardwired 6V) Installation:
When using the -HW6 power supply, attached provided inline connector between sensor and
control box to allow hardwired connection. When installing an IM model, make certain that the supplied solenoid Y connector is
connected so that both solenoids will recieve power.
13
SET SCREW
SIDE
SPRING
LOCK
SIDE
Before removing the spout, be sure to disconnect the sensor
cable below the deck so that the cable head can be pulled up
through the deck.
Note location of set screw and spring lock.
17
15
INLINE
CONNECTOR
-CWB
-HW6
-MJ
-HW6
SOLENOID Y
CONNECTOR
Note: If connecting more than one spout it is recommended that
the -MJ (Multi Junction) is used.
14
