FV563 Rev. - 12/2/14
Page 6
Loosening screw will cause sensor assembly to back out of spout
body. It may be necessary to push cable from connector end to
aid in sensor assembly removal. Firmly press into pocket and
tighten screw.
With spout disengaged, sensor assembly can now be removed
by loosening the center screw with provided 3mm hex wrench.
With assembly removed, you can now install new assembly and
reassemble your spout.
22
23
Sensor Assembly Replacement
24
25
To service solenoid use phillips head screw driver to remove
the screws on both sides of the black box.
With screws removed, the black box can slide off and allow
access to the solenoid for service.
Accessing the Solenoid
Use supplied 3/32” hex wrench to loosen set screw. Screw will
retract into the base to eliminate loss. Using the same hex wrench,
depress the ball detent to release spout from base.
Lift spout and pull sensor cable through deck and base.
19
18
20
Align spout so that the ball detent is between the 2 holes. Press
down and turn clockwise. Use hex wrench to back set screw out
to secure spout.
21
To reinstall faucet, first drop sensor cable of new spout through
the front of the base. Lower spout onto base inserting base nipple
into spout port.
