FV563 Rev. - 12/2/14
Page 2
IMPORTANT:
• All plumbing is to be installed in accordance with applicable codes and regulations.
• Water supply lines must be sized to provide an adequate volume of water to each fixture.
• Flush all water lines prior to valve installation to ensure proper operation.
- Particulates in the water can block small orifices within the valve which may result in continuous running.
• The use of toothed tools during installation or service of the faucet or its components may lead to premature failure.
Prior to Installation:
Before installing your Zurn
®
Aqua-FIT
TM
Faucet: the items listed
below should already be installed on site.
• Lavatory/sink
• Drain Line
• Hot and cold water supply line or pre-tempered water supply line.
The following tools may be necessary for installation:
• Non-toothed Wrench
• Phillips Head Screwdriver
• Allen Wrench (M3)
• Allen Wrench (3/32”)
If you are replacing an existing faucet or Aqua-FIT
TM
shells, turn off water supply and remove the old faucet. Clean lavatory rim around
the mounting area for the new sensor faucet.
Serio Series
TM
Faucets
3a. Electronics Box with Solenoid - Z6950/55-XL
3b. Electronics Box with Solenoid - Z6950-XL-IM
4.
Aerator and Key
5.
Mounting Kit
6.
Batteries
1a. Z6950 Spout Assembly
1b. Z6955 Spout Assembly
1c. Z6950-IM Spout Assembly
2a. Z6950 Spout base gasket
2b. Z6955 Spout base gasket
CARE AND CLEANING INSTRUCTIONS
DO NOT
use abrasive or chemical cleaners to clean faucets as they will dull the luster and attack the chrome or special decorative
finishes. Use only mild soap and water, then wipe dry with a clean cloth or towel. While cleaning the bathroom tile and floor, the faucet
and electronics should be protected from splattering of water, cleaner, acids and cleaning fluids that can damage the sensor faucet.
