Page | 15
Step 12 - Apply Wi-Fi Network Security Settings
By default, the ZuniDigital Travel Connect broadcasts as an OPEN network with no data encryption. If you wish
to enable network encryption to help secure your network, please select the encryption type you want to use,
establish a password that you can remember, and then click the “Finished” button. This will finalize the settings
for your Travel Router and you may begin using it as a wireless access point.
Step 13 – Using the Travel Router
Power the travel router ON and wait for it to fully boot and connect to the selected wireless network. It will
broadcast the SSID setup in step 9 which you can connect wireless devices to. Also, be aware that each time you
relocate the travel router you will need to re-configure it to connect with the wireless network at the new
location.
RESTORE FACTORY DEFAULT SETTINGS
Should you at any time with to restore the factory default settings press and hold the “Reset” button on the
bottom of the Travel Router for 8 seconds, then release. The travel router will re-boot and all of the original
factory settings will be restored.
