70 / 138
Identification: MD-AL-GI-00
Rev. 1.1 of 15/03/2021 - Application: GID
User’s Manual 3PH 50000TL-60000TL-V1
Rev. 1.1 15/03/2021
(D)
Press the “OK” key to enter the “Date and Time” menu.
Press the “Back” key in the main interface and the “Up” or “Down” keys to enter the submenu “4. Date and
Time”, then press “OK” to display the current date and time set on the inverter.
(A)
Press the “OK” key to enter the “Update Software” menu.
Press the “Back” key in the main interface and the “Up” or “Down” keys to enter the submenu “5. Software
Update ”, then press "OK" to enter. The display will show “Enter PWD!.” Press “OK” to enter the password
“0715” using the “Up” and “Down” keys to select the number and “OK” to move to the next digit and confirm.
If the display shows “Incorrect, try again!” press the “Back” key and enter the password again. When the
password has been entered correctly, you can enter the menu and start updating the firmware.
Note
:
you can check the firmware version currently installed on the inverter from the “Service Code” submenu
found in the “System Info” menu.
IMPORTANT
: Do not perform any update operation if there is no microSD card inside the inverter or if the
microSD card does not contain the appropriate update files. Always make sure that the correct update files
are loaded on the microSD card and that the card is correctly inserted in the appropriate slot.
Note:
the microSD card is not supplied with the inverter and must be procured by the installer or customer.
The complete and detailed procedure for updating the firmware is described below.
Update requirements
-
4 Gb MicroSD card
-
MicroSD to SD adapter or MicroSD to USB adapter for inserting the MicroSD card into the PC.
