Zubler VARIO S 400, Руководство по эксплуатации

Страница: 5 / 24

5
Seite Seite Seite Seite
Page
0 Introduction
■
The VARIO S 400 furnace series was developed
exclusively for the sintering of zirconium dioxi-
des in their different forms (standard, translu-
cent, full contour or dyed) and is intended only
for these applications.
■
All other uses require the written consent of
Zubler Gerätebau GmbH.
■ The user is liable for any damage resulting from
use other than that intended.
■
The manufacturer's warranty conditions apply.
■ Use within specifications also includes following
all the instructions in this operating manual.
■
The appliance may be operated only by technical
or trained personnel.
■ Repairs may be carried out only by authorized
service personal.
■
Do not touch the control panel with wet or
moist fingers.
■ Please unpack the furnace carefully. It should be
lifted/carried by two people. Always lift at the
base of the unit; never lift the furnace using the
chamber or the table guide.
■ Do not actuate the control panel with hard
and/or sharp objects.
■
Never operate the furnace without the insulation
base installed on the table.
■ Do not reach with your hand between the furna-
ce table and furnace chamber during operation.
There is a danger of being crushed or burned.
■ During operation, never reach underneath the
furnace table and never place anything under the
furnace table. The furnace table must not be
blocked during the opening process.
■ The cooling slits must not be covered or
obstructed, otherwise the circulation of air is not
guaranteed and the appliance could overheat.
■ No liquids or objects may be allowed to enter the
appliance or the vent openings, as it may cause
a short-circuit.
■ The furnace table has an electric drive and must
be operated using the buttons on the glass touch
control interface. Do not open or close the furna-
ce table by hand.
0.3 Use within specifications
Page