Zubler VARIO S 400, Руководство по эксплуатации

Страница: 20 / 24

20
4 Safety warnings!
Never place highly combustible materials such as
paper or brushes or highly flammable substances
such as methylated spirits, insulation spray or paint
near the sintering furnace.
■ Use this furnace only for its intended purpose as
described in this operating manual and carefully
remove all packaging materials and adhesive
tape during the installation.
■
The appliance may be used indoors only.
■ Materials that give off toxic gases must not be
sintered.
■
Fan openings must not be covered over. Danger
of overheating or safety cut-off of the furnace.
■ The appliance may be connected only to a separate
power socket protected by a 16 A slow-blow
fuse with an earth contact and a 30-mA earth
leakage circuit breaker.
■
Any interruption in the protective earth conductor
inside and outside the appliance or loosening of
the protective earth connection can lead to the
appliance posing a threat to the operator in the
event of an error. Intentional interruption is not
permissible.
■
Position the furnace in a free-standing position. A
free space of 200-300 mm must be maintained
around and above the furnace. Immediately
adjoining walls surrounding the appliance should
be made of a non-flammable material. The area
should be well ventilated.
■ In accordance with fire protection regulations,
install a suitable, recommended, multipurpose,
dry-foam fire extinguisher near the furnace and
make sure that your employees have been
instructed how to use it properly.
■
Never wear loosely-fitting clothes or clothes that
hang down when operating the furnace. Be
careful when grasping objects in the vicinity of
the furnace. Inflammable material can catch fire
if it comes into contact with a hot surface of the
appliance. The user can sustain severe burns as
a result.
■
Do not place the furnace in the immediate vicinity
of sources of heat (e.g. burnout furnaces, ceramic
and press furnaces).
■
Make sure that the furnace has been professio-
nally installed in accordance with our instructions
and that the selected electrical connection is
properly grounded.
■
Use the grounded appliance power cable IEC
C19 for 230/240 V.
■ The electrical service must be carefully performed
and must guarantee that the oven is connected
to sufficient voltage. Assign a qualified electrician
to install the proper outlet and voltage supply, so
that you can be sure that the connection is ade-
quate and that no existing circuit is overloaded.
■
Do not use an extension cable with the furnace.
Ask your electricity supply company about the
electrical connection values that apply to your
local grid.
■ The temperature may rise more slowly if the
voltage is too low.
■ Connections should be checked from time to
time to ensure that they are correctly seated and
that they are not worn or damaged. They should
be tightened again or replaced if necessary.
■
All cables should be located outside of
passageways and corridors.
■ High temperatures can be radiated during operation.
Page