25
4
3
5
4
5
2
1
5
1
2
5
4
3
2
1
2
1
Compound
Tape
Remove
surplus
compound
Remove
surplus
compound
Remove
surplus
compound
D
With all gaps and voids fi lled, bring
the conductors back together and
pack more compound around the
outside of the conductors. Tape
the conductors together to prevent
disturbance of the compound seal.
Pass the rubber pot
(4)
over pot cap
(3)
and remove any surplus com-
pound from the top of rubber pot
(4)
and joint faces as indicated.
E
Replace the entry
(5)
over the rubber
pot
(4)
ensuring that compound does
not cover end of rubber pot
(4).
F
Locate and hand tighten the sub-as-
sembly
(1)
and
(2)
to the entry
(5).
G
To further locate and support the
compound and rubber pot assem-
bly, while holding the middle nut
(2)
with a spanner/wrench, tighten the
backnut
(1)
until the seal grips
the cable to prevent movement of
the cable gland.
Important note:
The conductors must not be moved
for a minimum of four hours.
H
Allow the compound to cure.
(See
Fig. 7 for Curing Times).
Untighten fi rstly the backnut
(1)
from
(2)
and secondly the middle nut
(2)
from the entry
(5).
The rubber pot
(4)
may be removed for inspection to en-
sure that the packing is satisfactory.
Add further compound if necessary.
I
Re-assemble rubber pot
(4)
and the
entry
(5).
Hand tighten the sub-assem-
bly
(1)
and
(2)
to the entry
(5)
and add
half a turn to
(2)
with a spanner/wrench.
Tighten the backnut
(1)
to form a seal
around the cable, then tighten a further
half to full turn using a spanner/wrench.
Ensure that the middle nut
(2)
does not
rotate when tightening the backnut
(1).
Locate the shroud over the cable gland
if applicable.
Содержание Modact MOKP 100 Ex Series
Страница 2: ......
