Zoom GFX-8, Руководство по эксплуатации

Страница: 30 / 46

Using
RTM
The parameter to be controlled by RTM as well as the control
range can be freely set in edit mode. The steps for setting up and using
RTM are as follows.
1.
In play mode, select a patch for which RTM is set.
2.
Switch to edit mode, and use the DRIVE, ZNR/EQ
EDIT, MOD, DLY/REV keys to select the module to be
controlled by RTM.
3.
Turn the PARM SELECT knob until the display shows
"RTM CTL".
RTM CTL is the parameter that selects the controller for the
RTM action. The following settings are possible.
• oF
RTM is not used in the module.
• Pd
RTM is controlled with the expression pedal on the unit.
• 1 - 5, 8 - 31
RTM is controlled with the MIDI control change of the
respective control number.
4.
Turn the PARM VALUE knob to select "Pd".
The respective module can now be controlled with the
expression pedal.
5.
Turn the PARM SELECT knob until the display shows
"RTM DES".
RTM DES selects which effect parameter in that module is
controlled by RTM.
6.
Turn the PARM VALUE knob to select the number of
the parameter (1 - 4) to be controlled by RTM.
7.
Turn the PARM SELECT knob until the display shows
"RTM MAX", and use the PARM VALUE knob to set
the maximum value of the parameter.
For the effect parameter selected in step 6, RTM MAX
determines the maximum value that is established when the
expression pedal is pushed fully down (or when the value of the
received MIDI control change is 127).
Taking the maximum value of the controlled parameter as 100
(%), the setting can be made from 0% - 100% (setting value = 0
- 99, 1.0).
8.
Turn the PARM SELECT knob until the display shows
"RTM MIN", and use the PARM VALUE knob to set the
minimum value of the parameter.
For the effect parameter selected in step 6, RTM MIN
determines the minimum value that is established when the
expression pedal is fully raised (or when the value of the
received MIDI control change is 0).
Taking the maximum value of the controlled parameter as 100
(%), the setting can be made from 0% - 100% (setting value = 0
- 99, 1.0).
It is also possible to set RTM MIN to a higher value than
RTM MAX. For example, if the setting is RTM MAX = 0,
RTM MIN = 1.0, the parameter for that module becomes
smaller as the pedal is pushed and maximum when the
pedal is raised.
9.
Repeat steps 2 - 8 to make the RTM setting for other
modules in the same way.
The RTM parameters described above are available separately for
the DRIVE, EQ, MOD, DLY/REV modules. This makes it
possible to control several parameters in different modules
simultaneously.
It is also possible to assign the volume control to the
expression pedal. This setting is made with the VOL_RTM
parameter (see page 29) in the TOTAL module.
10.
Store the patch and return to play mode.
When the expression pedal is operated in this condition, the
assigned parameter changes within the preprogrammed range.
When the parameter was set to MAX=1.0 (100%), MIN=0
(0%), the expression pedal changes the parameter as follows.
HINT HINT
The RTM (real-time modulation) function can be operated either with the expression pedal on the top panel or by MIDI
control change messages input via a MIDI link. This can be used for example to change the reverb sound mix ratio during a
performance, using the expression pedal, or to control effect parameters during play, using a MIDI sequencer.
Using RTM
30
ZOOM GFX-8