ZOJE A5300, Инструкция по эксплуатации

Страница: 30 / 39

-26-
1.Turn the pulley until the feed dog ④ risesto the highest position.
2.Turn over the sewing machine head on the supporting bar.
3.Unscrewing the tightening screw
①
in theteeth pedestal
②
.
4.Adjust the eccentric pin ③ by screw driver:Fall front site of tooth feed when moving the eccentric
pin ③ towards A, and raising it when move towards B.(When raising the tooth feed to the highest
position, The standard lean position of feed dog is that mark C on eccentric pin ③ should be at the
same level D with mark on the teeth pedestal ② and the feed dog should be parallel with needle
plate.)
5.Remember to tighten the tightening screw ① in the teeth pedestal ② after adjusting
Caution:
1.To prevent the unexpected startup
of sewing machine, trim off the pow
-er supply before the operation is co
-nducted.
2.In order to prevent puckering,lowe
-r the front of the feed dog.
3.In order to prevent the material fro
-m slipping,raise the front of the feed
dog.
4.The height of the feed dog will cha
-nge after the angle has been adjust
-ed,so it will be necessary to re-adju
-st the height of the feed dog.
Fig.39
31
Replacing the fixed knife and movable knife
(Fig. 39, Fig. 40, Fig. 41)
②
③
④
①
ZOJE Europe 2022