ZOJE A5300, Инструкция по эксплуатации

Страница: 26 / 39

1)Lower the presser foot by using the lifting
lever.
②
2)Loosen the set screw .
3)Rotating the screw in the clamp to adju
③
-st, the stroke to the Thread take-up Spring
①
will increase when turning toward the clockwi
-se(A), otherwise decrease when toward ant
-i-clockwise (B).(The standard stroke, under
the state of presser foot was put down is arou
-nd 6~7mm higher than the slow hook)
4).Securely tighten the screw .
②
Caution:
1.To prevent the unexpected startup
of sewing machine, trim off the pow
-er supply before the operation is co
-nducted.
2.The take-up spring is already adju
-sted properly before the machine le
-aves the factory as a rule, and it req
-uires readjustment only for sewing
of special materials or usage of spe
-cial stitch threads.
Fig.34
③
B
C
A
D
B
C
A
D
①
DB × 1
DP × 5
DA × 1
①
①
②
26
Adjust the Height of the Needle Bar(Fig. 34)
1.Turn the machine pulley to set the needle
bar
①
to its lowest position.
2 .Remove the rubber cap
②
from the face
plate.
3.Unscrewing the connecting screw
③
of n
-eedle bar, through moving the needle bar
①
up and down to adjust, when using needle DB
X1 and DPX5, the mark A on the needle bar
①
should be match to the bottom of needle bar
lower bushing; When using DAX1, the mark C
-22-
ZOJE Europe 2022