44
5 Update Pattern via U disk
5.1 Operation for Updating Pattern
1
、
When the Sewing LED is off, operator can press
to have the screen
display
, and then the operator needs to press
at same time. When hearing the voice from buzzer, the operation can activate and modify the
service parameters;
2
、
Press
and
to select Parameter No.62
：
3
、
Press
to turn on the Sewing LED, then press
and
to change the function number
to “1”; press
again to confirm the function number and turn off the Sewing LED.
4
、
Please Pay Attention To The Differences Among The Operations Below
：
i.
If your machine uses the old type USB update module that doesn’t have USB port
on panel, please use the methods at below to perform the update operation:
1.
Turn off power; remove the panel plug at X7 port on controller and insert
the plug of pattern updater into the X7 port. The pattern updater is shown at
below
：
P1
P3
P5
Parameter No. 62 is used to update
the pattern
Mode Selection:
“0” is Normal Mode
“1” is Patten Update Mode
When the sewing LED is on, use
or
to change the mode
