24
24
CONNECTION
%
c
Check that the skimmer, filter and pre-filter of your pool pump are clean.
c
Direct the inlet jets for your pool downwards.
c
Close the main drain of your pool and all the other suction routes
not being used (skimmers or vacuum point).
c
Start up your pool pump.
c
Fill the
SUPER G+
hose with water flowing from the inlet jets, and
keep this hose under water throughout the remaining operations
%
IMPORTANT : You can connect your SUPER G+
hose to the skimmer or one of the skimmers, or to the vacuum
point. We strongly recommend that you connect it to one of
the skimmers to achieve more efficient cleaning.
CONNECTING TO THE SKIMMER OR ONE OF THE
SKIMMERS:
WARNING: The last sections must be connected together
under water so that there is absolutely no risk of air entering
the system and draining the pump.
c
Use the weir adapter to fit the automatic flow control valve in one
of the skimmers.
IMPORTANT :
The automatic flow adjustment valve is pre-set in the
factory to number 3, the most suitable position for European pools. For
an optimal performance from your cleaner, we recommend that you do
not move the valve from this position. Secondly, always check that the
valve’s dark grey flap is not held in the open position by the red lever –
otherwise your cleaner cannot function.
c
Connect the 1m hose section A onto the control valve, after having
filled it with water to remove any air, and pull the protective mesh.
c
Connect the leaf trap to the other end of the hose section A.
WARNING: Make sure that the arrow marked on the leaf
trap points correctly to the vacuum point, and not towards
your cleaner.
c
Check that there is no air in the hose assembly, then connect it to
the skimmer by joining the last hose section A to the leaf trap
&
.
A
A
&
