30
PROBLEM SOLVING
The SUPER G+ will not work :
c
use the pool pulse to check the flow (see page 27).
If the flow rate is too low:
c
make sure the main sump valve is properly closed ;
c
make sure the filter and skimmer baskets are quite clean ;
c
make sure the hose and automatic control valve are correctly
connected.
IMPORTANT :
The automatic flow adjustment valve is pre-set in the
factory to number 3, the most suitable position for European pools. For
an optimal performance from your cleaner, we recommend that you do
not move the valve from this position. Secondly, always check that the
valve’s dark grey flap is not held in the open position by the red lever –
otherwise your cleaner cannot function.
If the flow rate is correct :
c
make sure the automatic pool cleaner suction point is not blocked
by debris ;
c
is the diaphragm (see page 29) of the automatic pool cleaner
damaged ?
The SUPER G+ does not clean all parts of the pool :
c
to ensure that the entire pool is cleaned the filtration system
operating time can be reduced. For example, 6 hours filtration in 3
two hour sessions will give better coverage of the pool than a single
6 hour filtering session.
c
is the hose long enough ? Add sections if necessary ;
c
have you set the inlet jets so that they point towards the bottom
of the pool ?
c
is the hose in perfect condition ? (see storage advice, page 22).
The SUPER G+ travels round the pool and rarely goes to
the centre :
c
Test the flow (see page 27). If the flow is correct, remove the top
disc and run the cleaner with the main disc only
.
16
3
2
1
2 m
Main
disc
Top disc
16