25
CONNECTING TO THE VACUUM POINT:
WARNING: The last sections must be connected together
under water so that there is absolutely no risk of air entering
the system and draining the pump.
c
Use the weir adapter to fit the automatic flow control valve onto
the vacuum point.
IMPORTANT :
The automatic flow adjustment valve is pre-set in the
factory to number 3, the most suitable position for European pools. For
an optimal performance from your cleaner, we recommend that you do
not move the valve from this position. Secondly, always check that the
valve’s dark grey flap is not held in the open position by the red lever –
otherwise your cleaner cannot function.
c
Connect the 1m hose section A to the automatic control valve,
after removing any air by filling it with water.
c
Connect the leaf trap to the other end of the hose section A,
after also having filled this with water.
WARNING: Make sure that the arrow marked on the leaf
trap points correctly to the vacuum point, and not towards
your cleaner.
Check that there is no air in the hose assembly, then connect it to the
vacuum point by joining the last hose section A to the leaf trap.
'
.
NOTE: You can connect your SUPER G+ to the vacuum
point without using the automatic flow control valve (see
diagram below), and can then control the flow rate by
partially opening the skimmer(s)
(
.
You must then use the flow tester supplied in the pack to
check that you have the correct suction flow rate in your
pool for your SUPER G+ to work properly (see page 27).
A
A
(
A
A
'