3
•
If the power cord is damaged, it must be replaced by the manufacturer, its technician
or a qualified person to guarantee safety.
•
Do not perform maintenance or servicing operations on the appliance with wet
hands or if the appliance is wet.
•
Before connecting the appliance to the power supply, check that the connection
unit or socket to which the appliance will be connected is in good condition and
shows no signs of damage or rust.
•
For any component or sub-assembly containing a battery: do not recharge or
dismantle the battery, or throw it into a fire. Do not expose it to high temperatures
or direct sunlight.
•
In stormy weather, disconnect the appliance from the power supply to prevent it
from suffering lightning damage.
•
Do not immerse the appliance in water (with the exception of cleaners) or mud.
WARNINGS CONCERNING APPLIANCES CONTAINING REFRIGERANT
•
This appliance contains R32 refrigerant, which is classed under category A2L as
mildly flammable (models PM40 MD1, MD2, MD3, MD4, MD5, TD7 and TD8).
•
No not release R32 refrigerant (models PM40 MD1, MD2, MD3, MD4, MD5, TD7 and
TD8) or R410A refrigerant (models PM40 MD7, MD8, TD12) into the atmosphere.
These are fluorinated greenhouse gases, covered by the Kyoto Protocol, with a
Global Warming Potential (GWP) of 675 for R32 and 2088 for R410A (European
regulation EU 517/2014).
•
In order to comply with the applicable standards and regulations in terms of the
environment and installation, in particular French decree No. 2015-1790 and/or
European regulation EU 517/2014, a leak test must be performed on the cooling
circuit at least once a year. This operation must be carried out by a specialist
certified to test cooling appliances.
•
The appliance must be stored in a well-ventilated location away from all ignition
sources.
• Install the unit outdoors. Do not install the unit indoors or in an enclosed and non-
ventilated outdoor location.
•
Do not use means for accelerating the defrosting or cleaning process other than
those recommended by the manufacturer.
•
The appliance must be stored in a room without any permanent ignition source
(such as open flames, operating gas appliance or operating electric heating).
•
No not perforate or incinerate.
•
Please note that R32 refrigerant may give off a certain odour.
INSTALLATION AND MAINTENANCE
•
The appliance may not be installed close to combustible materials, or the air duct
inlet of an adjacent building.
•
With some appliances, it is essential to fit a "protection grid"-type accessory if the
unit is installed in an area with uncontrolled access.
•
During installation, troubleshooting and maintenance, pipes may not be used as
steps: the pipe could break under the weight, spilling refrigerant and possibly
causing serious burns.
•
When servicing the appliance, the composition and state of the heat transfer fluid
EN
Содержание PM40 Series
Страница 2: ......
