Zodiac FloPro VS, Инструкция по установке и эксплуатации

Страница: 20 / 23

18
3.6 I Additi onal functi ons for professionals only (model with interface only)
To enter the service menu, the pump must be stopped.
Press and hold , and at the same ti me for 5 seconds: .
Use the or keys to browse the menu.
To exit the menu, press the key or refrain from performing any acti ons for 1 minute.
Limit the pump's minimum operati ng speed. The user will no longer be able to
set the pre-defi ned speeds 2, 3, 4, 5, 6, 7 and 8 below this speed. The default
speed is 600 rpm.
Limit the pump's maximum operati ng speed. The user will no longer be able to
set the pre-defi ned speeds 2, 3, 4, 5, 6, 7 and 8 above this speed. The default
speed is 3,450 rpm.
Restore factory setti ngs:
Setti ng By default Possible values
"eStar" speed 1,750 rpm
from 600 to 3,450 rpm, in
intervals of 10 rpm
Speed 2, 3, 4, 5, 6, 7
and 8
2,750 rpm
Priming speed 2,750 rpm
Frost protecti on ti me 30 minutes
from 0 minutes to 8 hours in
30-minute intervals
Priming ti me 3 minutes
from 1 to 5 minutes in 1-minute
intervals
View the last 2 pump errors. If the memory contains no errors, the display will
show:
A priming speed greater than 2,500 rpm is highly recommended in order for it to
be eff ecti ve.
To set the priming speed (from 600 to 3,450 rpm):
Then the priming cycle ti me (from 1 to 5 minutes):
The user interface displays:
/
when the pump is in the priming cycle.
To set the pre-defi ned "eStar" speed (known by default as "1: Filtrati on").
The pump measures the running motor temperature and esti mates the water
temperature.
It acti vates the "eStar" speed if the temperature falls too low, in order to protect
the pump from freezing temperatures. This setti ng is used to confi gure the
durati on of the frost protecti on cycle.
To set the ti me (from 0 minutes to 8 hours in 30-minute intervals).
To deacti vate this functi on, set the ti me to "0:00".
• The frost protecti on functi on is only designed to protect the appliance and pipework during short periods
of subzero temperatures. It acti vates the fi ltrati on pump and circulates water to prevent freezing inside
the appliance. The frost protecti on functi on does not guarantee protecti on during extended periods of
subzero temperatures or power cuts. In these conditi ons, the pool must be completely winterised. If the
pump freezes, it may cause severe damage and invalidate the warranty.
This setti ng is used to determine the maximum allowable pump speed depending
on the type of pump chosen.
We recommend not changing this setti ng to keep opti mum pump performance.
You can display the pump's electricity consumpti on while running (in Watt s).
This setti ng is only displayed on the screen when the pump is running: