ZMC408CE Motion Controller Hardware Manual V1.5
"speed" according to the needs, and use the "CANIO_ENABLE" command to enable or
disable the internal CAN master function, or through "ZDevelop/Controller/State the
Controller/Communication
Info” to
view the CAN status intuitively, and refer to the
“ZBasic Programming Manual” for details
.
(4)
Correctly set the "address" and "speed" of the slave station expansion module
according to the manual of the slave station.
(5)
After all the settings are completed, restart the power supply of all stations to
establish communication.
(6)
Note that the "speed" settings of each node on the CAN bus must be consistent, and
the "address" settings cannot cause conflicts, otherwise the "ALM" alarm light will be
on, and the communication establishment will fail or the communication will be
disordered.
3.2.
IN Digital Input & High-Speed Latch Port
The digital input adopts 3 groups of 10Pin (there are 3 groups of 10 terminals) screw-
type pluggable terminals, and the gap distance between terminals should be 3.81mm. In
addition, the high-speed latch function is integrated in digital input signal.
Содержание ZMC408CE
Страница 1: ......
