Zmorph VX, Руководство по эксплуатации продукта

Страница: 8 / 163

Health and safety
8
2.2 Occupational hygiene
• Special care must be taken when carrying out a repair, maintenance or servicing oper-
ations. The user is exposed to high temperatures. Protective gloves are recommended.
• It is recommended that a dedicated space with adequate ventilation is provided for
the device. It is not recommended that you stay in the same room where the device is
working continuously.
• Fumes emitted during 3D printing or laser engraving can be hazardous, depending
on the material used. Some substances, in combination with accumulated dust, can
have a negative effect on people in the long-term exposure.
• The noise emitted when working with 3D printing toolheads is 45 dB and when milling
is less than 70 dB, but continuous presence in one room can cause discomfort to the
user.
• Place the device on a stable and flat surface.
• The device is equipped with a vibration-damping base.
• Follow the toolhead cable descriptions while connecting them to the machine and do
not connect devices that are not authorized by the manufacturer.
• Do not use materials that may damage the device or that are not authorized for use
with the toolheads.
• When using ZMorph VX, ensure all necessary health and safety measures as de-
scribed in this manual and separate regulations.
• Handle the sharp accessories and tools included with the kit with special caution.
2.3 Electrical safety and risk
ZMorph VX devices have been tested to comply with the Low Voltage Directive. In order
to ensure maximum safety of use, including protection against short circuits, overloads,
overvoltages and overheating of the product, the following provisions must be observed:
• Do not modify the machine, toolheads and its electronic components.
• Do not use electronic substitutes other than those recommended by the manufacturer.
• Replacement of electronic components should be done in accordance with the rec-
ommendations and instructions provided by the manufacturer.
• Before connecting the 3D printer to the power outlet, make sure that the voltage re-
quired by the device corresponds to the voltage available from the power source. For
power supply information, refer to the nameplate on the rear of the device.
• Avoid overloading the power outlet to which the 3D printer is connected.
• The device must be properly grounded. Always make sure that the grounding is in
accordance with local and national regulations.