Swing Gate Opener
User Manual
P a g e
| 25
Copyright©2022 ZKTECO CO., LTD. All rights reserved.
learning the rotor-locked current value), then the door will close automatically. After the 2 swings
are fully closed and the display showing
, running travel setting is finished. Please verify the
correct installation by pressing the opening/closing button on the remote transmitter.
The slow stop is activated after the travel setting, if the slow stop speed is too slow, please adjust
‘TR1’ to increase. If slow stop speed is too fast, please adjust ‘TR1’ to decrease.
Note:
If the door is not need to be fully opened, please install the limit stopper at the proper position.
Trimmers Setting
Slow down speed trimmer regulates the slow down speed. Do not set the speed to low (less than 10
cm/sec on the wing edge) to avoid the gate stops in too cold conditions.
Obstacle sensibility trimmer fine tunes the obstacle detection level learned by the control unit
during working times programming. This fine regulation must be done after working times learning.
Normally the trimmer goes into the center, in this position should be possible to respect rules in
most installations. If its needed to resolve problems related to norms or environmental situations (ex.
Strong wind) is it possible to regulate this trimmer by increasing or decreasing sensibility.
Learning Transmitter & Delete Transmitter
Press button TS3, display shows, press the button you want to program, and until the display shows
digital, learning is finished.
（
The default remote control mode is Step by Step
）
Press button TS3 and hold on until the display shows, all the remotes have been deleted.
Figure 15
