SpeedFace-V5L Series
User Manual
P a g e
| 64
Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Detection Management
★
Click
Detection Management
on the System interface.
Function Name
Description
Enable Temperature
Screening with
Infrared
To enable or disable the infrared temperature measurement function.
When this function is enabled, before the access is granted, users must pass
the temperature screening in addition to identity verification.
To measure body temperature, users’ faces must be aligned with the
temperature measurement area.
High Temperature
Alarm Threshold
To set the value of the alarm threshold of high body temperature.
When the temperature measured during verification is higher than the set
value, the device will give a prompt and audio alarm.
The default alarm threshold is 37.30
℃
.
Temperature Over
the Range; Access
Denied
When this function is enabled, if the user’s body temperature measured is
above (or below) the alarm threshold, the user will not be granted access even
if his/her identity is verified.
If this function is disabled, the user is allowed to access the restricted area
when his/her identity is verified, regardless of his/her body temperature.
Temperature
Deviation Correction
As the temperature measurement module allows a small range of errors
(disturbance) of an observed value under different environments (humidity,
room temperature and such), users may set the deviation value here.
Temp. Unit
The unit of body temperature can be switched between Celsius (
℃
) and
Fahrenheit (
℉
).
