Zippkits JAE GAS OutriggerV2, Инструкция по сборке

Страница: 26 / 39

26
Pipe mount.
Pipe mount inside
tub.
Acid brush bent for “all up and under”.
Pipe mount
We used a Zipp 2016 pipe mount with the lower
portion cut off.
Try to get the pipe mount in the “bait box” area of
the tub so that you are not drilling into the radio
box.
We simply bolted this to the tub side.
Note that our tuned pipes are handmade and not
perfectly concentric. While this makes no
difference for performance, it does mean that you
can rotate the pipe to get the distance from the
mount to the tub correct.
Remove everything in preparation for sealing.
Sealing
Use epoxy finishing resin, West Systems epoxy,
or our favorite, Klass Kote epoxy paint to seal the
inside of the tub.
Brush a coat of epoxy into all areas in the tub. Be
sure to get the servo mounts and the underside
of the lid frame. Use an acid brush bent at an
angle to do this.
Seal the inside and outside of the carb shield.
You can also seal the inside and outside of the
ski as well.
Allow to cure, sand lightly and apply a second
coat to everything.