Zippkits JAE GAS OutriggerV2, Инструкция по сборке

Страница: 22 / 39

22
Another view.
Radio box lid frame in place.
Tub top taped in place. Note that it is centered on radio box
lip.
Use either a “Z” bend or an EZ connector at the
servo.
Glue the servo mounts to the tub floor.
Don’t get any glue on the servo.
Allow to cure.
Remove everything from the tub.
Top Deck
The first step is to get the tub blocked up so that
it is flat on the bench. You can use pieces of ¾
ply or some scrap wood at least ¾ inch thick.
When we attach the deck, we will “lock in” the
shape of the tub. If there is any twist, this will
make it permanent.
Make sure that there is no twist.
if you want to be perfect, you can put the boom
tubes in place and measure from the bench to be
sure that the tub is level.
Before we get to the top deck, we need to glue in
the radio box lid frame.
This frame provides the “lip” around the radio box
for the lit to sit in.
Check all around the area where the frame will
go, and look for any glue that will prevent it from
sitting flush with the outer sides.
If you find anything, a single edge razor can be
used to scrape it away.
Once you are happy with the fit of the lid frame,
glue it in place.