14
Drilling holes for mounts.
Right angle drill is handy.
Shaft tube aligned properly.
Use a center punch or nail to mark the center for
your hole.
Drill this hole ¼ inch, and mount the engine.
With the engine in place, we can move on to the
shaft tube.
Slide your 5/16 shaft tube in until it is about ¼
inch from the collet.
Make a small mark where your 5/16 tube goes
through the bulkhead.
Make another mark about 6 inches past the back
of the boat.
Cut the brass tube here.
The 5/16 inch brass tubing needs to be
annealed.
This will make it easy to bend by hand, without
kinks.
Only anneal the brass tube from the mark you
made rearward. We don’t want to anneal the
forward portion that sticks through the bulkhead.
Содержание JAE GAS OutriggerV2
Страница 6: ...6 1 8 plywood parts plywood parts ...
