Zippkits JAE GAS OutriggerV2, Инструкция по сборке

Страница: 23 / 39

23
Pine tub nose block in place. Sand to match tub.
Tub top taped in place. Note that it is centered on radio box
lip.
Parts for carb shield
Tape and weight this, and be sure that it is all the
way against bulkhead 3.
Allow to cure.
Once the lid frame is cured, sand the entire top of
the tub in preparation for the top deck.
Test fit the top deck, and be sure that you center
the “lip” in the radio box area, and that there is a
little overhang all around.
When you are happy with the fit of the top deck,
mark the bottom and mix up some 30 minute
epoxy.
Using a brush or scraper, coat the underside of
the deck with epoxy. Get the whole deck as it
needs to be waterproof. Work quickly.
Coat the tops of the bulkheads and tub sides.
Also coat the top of the lid frame.
Again, work quickly.
Set the deck in place and start taping it to the tub
and bulkheads.
Use weights so that it is in contact at all points
and be sure that it is centered on the lid frame.
Double check to make sure the deck is in the
correct position and in contact all around.
Allow to cure.
Carb Shield
The carb shield included in this kit is designed to
prevent engine damage from water ingestion. Be
sure to ALWAYS run some sort of shield, as
even a fine mist can damage your engine…