Zippkits J.A.E. RACING Envy GAS Outrigger, Инструкция по сборке, Страница: 8 / 42

8
Tub sides before assembly.
Ledge for radio box lid frame.
Tub sides laminated.
Tub
Let’s build the tub.
The tub sides are laminated from 2 pieces of 1/8
ply, so take your time and make sure you
understand the tub assembly before you glue
anything.
First, note the insides of the inner tub right and
left are marked.
The Envy was designed so that when 2 parts are
laminated together, their laser marks will face
each other. If you are preparing to laminate 2
parts, and you can see writing, check again.
Notice the little “ledge” at the rear of the inner
sides. This is for the radio box lid frame.
Glue the inner sides to the outers, making sure
that you have a RIGHT and a LEFT side (they
are mirror images of each other).
Use the aluminum boom tubes to ensure perfect
alignment of the inner and outer sides.
Try not to get any glue in the slots for the
bulkheads or in the ledge. If you do, scrape it out
as it will make assembly difficult.
Be sure that the rear of the sides are flush at the
bottom, and have the 1/16 gap at the top ledge.
Check to make sure that the sides have not
slipped out of alignment.
Allow to cure.