Zippkits J.A.E. RACING Envy GAS Outrigger, Инструкция по сборке, Страница: 17 / 42

17
Epoxy with filler in place.
Be sure to pack the epoxy around the tube.
Tape on tub bottom, around shaft tube.
When cool, use a Scotch Brite pad or coarse
sandpaper to scuff the brass tube.
Put the shaft tube through the hole in the tub
bottom, and through bulkhead 3.
Put the end that you didn’t anneal towards the
engine.
The tube should start ¼ inch behind the engine,
and continue about 6 inches behind the transom.
Glue the shaft tube in place with epoxy and filler
(to thicken).
Be sure to sand the shaft tube where the epoxy
will be.
To prevent epoxy from running out the bottom of
the slot, use tape to make a “dam” on the bottom
of the tub.
Allow to cure fully before touching anything.