Zippkits J.A.E. RACING Envy GAS Outrigger, Инструкция по сборке, Страница: 28 / 42

28
Pine tub nose block in place. Sand to match tub.
Trim tub side for carb clearance (JAE Gas V2 shown).
Again, work quickly.
Set the deck in place and start taping it to the tub
and bulkheads.
Use weights so that it is in contact at all points
and be sure that it is centered on the lid frame.
Double check to make sure the deck is in the
correct position and in contact all around.
Allow to cure.
Sand the top deck flush all around. Sand the
front of the tub flat for the nose block.
Glue the pine nose block in place, allowing a little
overhang all around. Tape in place until cured.
When cured, sand to match the tub and round
off.
Install your engine and carb.
You will need to cut the tub side for carb
clearance. Only remove enough material to clear
the carb as removing too much will weaken the
tub.
.