Zippkits J.A.E. RACING Envy GAS Outrigger, Инструкция по сборке, Страница: 14 / 42

14
This is what makes a JAE a JAE… Sponsons are
similar.
Bamboo skewers glued in place.
Sanded flush.
This is one of the things that make this such an
efficient design. By keeping all rear breaks sharp,
water is not allowed to stick, and is encouraged
to shear off cleanly, for much less drag.
Drill two 1/8 inch holes through the tub sides, into
the transom. Make these about ¾ inch deep.
Cut 4 pieces of bamboo skewer about an inch
long.
Put a drop of glue in the hole, and hammer the
skewer in each hole until it bottoms out. Allow to
cure.
Cut the skewer with side cutters and sand flush.
The transom is now permanently attached,
without the need for any additional reinforcement.