Zippkits J.A.E. RACING Envy GAS Outrigger, Инструкция по сборке, Страница: 23 / 42

23
Rudder servo mounts being laminated.
Servo mount assembled.
Quarter scale servo in place on mount.
sits flat.
Clamp until cured.
Laminate the servo strap the same way.
Check the height of your servo. The mount
should be a tiny bit shorter than your servo.
If necessary, sand the top of the mounts slightly
until the servo is about 1/32 inch taller.
Set the ¼ ply strap in place and drill pilot holes
with a 1/16 bit.
Do not omit these or the ply will split.
Put the servo in place and clamp it down with the
strap and 4 servo screws.
Notice that the screws only need to be snug to
hold the servo securely in place.
This mount puts the servo arm in the correct
position for a straight pushrod run to the rudder.
We will use the innermost servo arm hole.
Thread a 4-40 ball link onto a 4/40 pushrod.
Slip this into the hole in the transom and
bulkhead and attach it to the rudder with a 4-40
screw and nut.
Sand the bottom of the servo mount so that it is
flat.
Put the servo/mount assembly in position about 1
inch forward of the rear bulkhead.
Mark the pushrod where the servo output shaft
is.
Remove the pushrod.
Cut the pushrod and solder a clevis in place so
that its pin is where the mark was.
Put the pushrod back in place.