11
If you are using the front mounted servo (nitro
applications):
Attach your steering servo the servo tray and set it in the
radio box.
Level the tray front to back, and side to side.
Mark the top of the tray onto the sides.
Glue the two 1/8 servo tray rails (R) in place at your line.
You can glue them anywhere (front to back), but we like
the servo forward. We left about 1-1/2 inches in front of
the rails.
These are used to support both sides of the tray,
underneath. Don't glue the tray in yet, only the rails.
If you are planning on only using an electric motor for
power, you can skip the servo tray.
Sealing
Wood boats need two coats of epoxy resin to all exposed
wood, inside and out.
Here is the sealing method we use:
Put tape on the inside of the fuselage over the bottom
slots.
These slots are for the stumble blocks added later.
If you get any sealer in these, you will not be able to
properly fit the stumble blocks.
Tape over the slots and just seal right over the tape.
We will be sealing:
Fuselage insides
One side of cross grain decks (both)
Radio box top and lid
Mix about 4 ounces of epoxy sealer.
Brush on a coat of epoxy to the inside of the fuselage on
either side. Get epoxy everywhere.
Содержание G30
Страница 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Страница 24: ...24...
Страница 25: ...25...