16
Now you can seal the rest of the boat. Do it the same way.
Coat everything with sealing epoxy, then wipe it off with
paper towels.
Use lint free paper towels from a box.
They are much stronger than normal.
Wipe off the outside of everything.
Wipe off all epoxy until there is no gloss.
Allow to cure.
Scrape the sponsons, decks and fuselage with a utility
knife blade held straight up.
Scrape back and forth.
You will find that this is very quick, and gives a smooth
finish, ready for the next coat of sealer.
Use 220 grit paper to lightly smooth the corners and nose.
For the second coat of sealer, remember that this will be
the finish coat.
A smooth, flowing coat will make painting much easier.
Thin the epoxy about 10-20% with lacquer thinner. Mix
very well.
With a soft brush, paint on a smooth coat, and let it flow
out.
Try for a smooth coat without runs or brush strokes.
Be sure to seal up inside the stumble blocks.
Allow to cure.
Содержание G30
Страница 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Страница 24: ...24...
Страница 25: ...25...