![background image](http://html1.mh-extra.com/html/zippkits/g30/g30_manual_3806551019.webp)
19
Continue to hold the chin in position and keep pushing it
forward. Hold until the glue sets for a minute or two
Once the glue sets, remove the cowl and run a bead of CA
on the inside of the chin.
You can fill the area on the bottom if you want, but it’s
not structurally necessary.
We used finishing epoxy and micro balloons to make a
white filler for the seam. We sanded it for a nice smooth
transition.
Check the fit of the cowling and chin.
Sand the inside 2 inches of the chin and glue in the cowl
tongue.
Glue it so that it is centered, and has 1 inch sticking
forward.
Finally, seal the tongue and stiffeners with 2 coats of
sealer.
Don’t forget to add some floatation to the cowling. Plastic
does not float. At all. Don’t ask. Twice.
A piece of pool noodle glued in with Goop or silicone
RTV works well.
The rear of the cowl can be held in place with screws, or
with HD Velcro like we used.
Setup
Drill out the holes in the transom if using an OS lower
unit.
Install the blind nuts with a little glue.
The small rectangular hole in bulkhead 2 is for a servo
extension when using an Electronic Speed Control.
We use GOOP to glue the female end of a servo extension
here for the speed control.
Engine or Motor
Install the lower unit with either .21 engine or electric
motor to the transom with the 6-32 screws and washers.
Set the engine so that the propshaft center line is even
with the sponson bottoms and perfectly level.
Содержание G30
Страница 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Страница 24: ...24...
Страница 25: ...25...