![background image](http://html1.mh-extra.com/html/zippkits/g30/g30_manual_3806551005.webp)
5
Now that you have two sponsons, this is starting to look
like something. And look at what a good job you did with
following instructions and all!
Since you are a foam cutting pro now, the rest will be
easier.
Sponson Sheeting
Glue an Inside (INSIDE) in place on the sponson. Try to
do this on a very flat surface.
To glue the sponson sheeting in place, we like to use 30
minute epoxy. Just use a scrap of thin ply or an old credit
card as a squeegee, and put a thin coat on foam and
plywood. Work quickly. Use pins and tape to hold in
place.
Remove the pins after you tape, or they will interfere with
the next step.
Put some waxed paper down and set the sponson on the
waxed paper, inside down, until cured.
Put some weights on the sponson to keep it flat.
We do this so that the sponson inside will be straight and
true. Everything else is based on the inside, so take the
time and do this right.
Do the other side the same way. Allow to cure for at least
3 hours.
You can now glue the outsides (OUT) in place. This is
also curved on top, and the pointy goes forward.
Line them up so that they are even at the ends of the top
(curved) part of the sponson at the front and rear.
See OVERLAY page at the back of this manual.
Pin, tape and weight the outside until cured.
Содержание G30
Страница 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Страница 24: ...24...
Страница 25: ...25...