ZIMO StEin, Инструкция по эксплуатации

Страница: 5 / 35

StEin
Stationary Equipment Module Page 5
In the example shown above, all the power for the layout’s track and accessories
is supplied by the MX10 command station (actually the power supply unit up-
stream) from the pins “S1” and “S2” of the “DC out” socket, but also the
DCC power amplifier of the MX10 track outputs “Schiene 1” or “Schiene 2”.
Cab MX32(FU) or
MX33(FU) tethered
CAN bus (6-pin) To computer
(if system and StEin module is to work to-
gether with a dispatcher program)
6 -pin CAN bus cable to the front
MX10 CAN socket
8 -pin network cable
to the
rear MX10
LAN socket
CAN bus ( 8 -pin)
8 -pin CAN bus cable (network cable de-
sign) to the rear MX10
CAN socket
Turnout connec-
tions
1 … 8
Logic inputs
1 … 16
Servo
connections
1 … 8
planned planned
MX10 command station back side
StEin extension boards
planned
StEin module STEIN88V
Turnout connec-
tions
1 … 8
Logic inputs
1 … 16
2 x Speaker
I
2
C Bus for
signals
8 Signal lights
8 Signal lights
8 Signal lights
8 Signal lights
8 Signal lights
8 Signal lights
Up to 16 ICA boards
per “StEin”
Connect the
I 2 C
bus
i
n a daisy
chain as shown (NOT in parallel)
Additional StEin Modules
STEIN88V and STEIN80G
Isolated rail sections: connected to the StEin outputs
marked “P”.
Continuous rail: connected to the StEin output marked
“N” or the MX10 output “N”.
Track outputs 1 … 8:
for common “N-rail” and
individual “P-rail” sections
All “N” pins are
internally parallel
To track 2
(Programming track)
ATTENTION: The DCC output “Schiene 2” is supplied by the same pow-
er source as the output “DC out S2”, which in this application example is
also used for the StEin to control turnouts and signals.
Therefore, the voltage and short-circuit handling is the same.
DC out S2
(for accessory power;
which
the StEin uses to operate turnouts etc.)
To track 1,
for layout track that is NOT
connected to StEin modules.
Common GROUND
(= System ground)
DC out S1
(Track voltage
;
from this the StEin produces the DCC signal for the track outputs
1 … 8, the same way as the MX10 does for the “Schiene 1” output
Power Supply
Alternatively, a separate power supply can be
used to power accessories
from MX10
command
station
Common GROUND
(= System ground)
DC out S1
(Track voltage)
Accessory power from a ded-
icated power supply (i.e.
NGULF);
which the StEin uses to
operate turnouts etc.
to the StEin
to the StEin
In the example shown above, all the power for the layout’s track and accessories is
supplied by the
MX10 command station (actually the power supply unit upstream) from the pins “S1”
and “S2” of the “DC out” socket, but also the DCC power amplifier of the MX10
track outputs “Schiene 1” or “Schiene 2”.
In other more elaborate setups (e.g. if boosters are added) the
"Power and Distribu-
tion Board" MX10AVP is used.