Operation instructions
8.2 Performing the treatment
8
Page 14
Note:
The following descriptions are based on the factory settings.
Note:
All buttons, menus and sub-menus can be activated directly on the screen
with finger pressure.
Open therapy screen Activating the “Start” button opens the therapy screen.
Select electrode
Select the capacitive or resistive electrode suitable for your desired therapy
and insert it correctly into the handpiece.
Select common
electrode
Apply ThermoTK
cream
Select the common electrode suitable for your desired therapy.
Apply the ThermoTK cream to the treatment area and spread the cream
evenly over the entire surface of the treatment area.
For sensitive patients, it is recommended to also apply cream to the common
electrode.
Note:
Place electrode
Adjust power
In general, when self-adhesive electrodes are used, no ThermoTK cream is
needed. The contact area of the common electrode on the skin should never
be smaller than the area of the treatment electrode. Therapy without a
common electrode is not possible.
Placement of the electrode on the selected treatment point/area.
Adjustment of the desired power using the left-hand adjuster.
The power adjusted is shown in the bar graph.
Start of therapy
Note:
Note:
Note:
Activating the “Start“ button starts the therapy.
If the "Start" button is not activated, no power is emitted.
The power can be increased or decreased during therapy using the adjuster.
The therapy should not be started until the electrode is placed on the patient.
End of therapy:
Note:
An acoustic signal sounds after the therapy time has elapsed.
2-phase program:
When a 2-phase program is used, the mode must be manually adjusted for
phase 2 after phase 1 has elapsed, the electrodes must be changed
accordingly, and the recommended therapy must be adjusted. The therapy
must be restarted for phase 2.
